Micromod Micro-DCI: 53SL5100A Single Loop Controller - Manual (Page 10)

Single Loop Process Controller Instruction Manual
2 Introduction
parameters in tables, by function.
• Section 5, Single Loop (PID) Controller , Section 6, Analog Backup Controller ,
Section 7, Ratio (PID) Controller , Section 8, Automatic/Manual Station
Sections 5, 6, 7 and 8 use the same structure for presentation, but differ in content. Each
section provides:
• overview information of the instrument in a process loop,
• the block diagram of the instrument for that specific application,
• an explanation of the front panel push button functions,
• a configuration example of the display, and
• abbreviated configuration tables
• Section 9, Parameter Display : This section provides procedures to edit parameter values and
to configure the Parameter Display.
• Section 10, Instrument Tuning : This section provides three methods to tune the instrument:
Trial and Error, Proportional Cycle, and Step Response (Ziegler-Nichols).
• Section 11, EASY-TUNE : This section provides information to initiate EASY-TUNE and to
modify the tuning parameters. It also provides definitions of the tuning sequence status pa ra
meters .
• Section 12, Maintenance : This section provides the calibration information for the analog
input/output zero and span settings. It also has the hardware reset procedure, parts list, and
illustrated parts breakdown of the instrument.
• Appendix A, Discrete Contact Output CCO : This appendix illustrates various circuit layouts for
the Discrete Contact Output CCO0.
• Appendix B, Communications : This appendix provides reference information for the binary
communication mode.
• Appendix C, Database : This appendix lists all of the database parameters in alphanumeric
order.