Micromod Micro-DCI: 53SL5100A Single Loop Controller - Manual (Page 31)

Single Loop Process Controller Instruction Manual
Front Panel 23
3.3 Front Panel Pushbuttons
The front panel pushbuttons are used to vary the display presentation, to select instrument operator or
engineering modes, and to select local or remote setpoint levels. In engineering mode, (EMODE) they are
also used to display and/or alter database parameters which are presented as single line datapoints in the
configuration overlay.
Pushbutton operator mode functions differ slightly with each control strategy implemented; however, the
engineering mode pushbutton functions are identical for all four control strategies.
General pushbutton functions are illustrated in Figure 3-8 below and defined in Table 3-1 on the facing
page. The summary table in Figure 3-8 shows the functional differences of the push buttons by control
Figure 3-7. Configure Overlay