B&B Electronics EIRM-EXTEND-8 - Manual - Manual (Page 87)

Manual Documentation Number: EIRM-EXTEND-8-1411m 81
B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 – www.bb-elec.com
B&B Electronics – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445 – www.bb-europe.com
Command Line Console Management
The Ethernet Extender Switch provides a command line console interface
for configuration purposes. The Ethernet Extender Switch can be
configured either locally through its RS-232 port or remotely via a Telnet
session. For the later, you must specify an IP address for the Ethernet
Extender Switch first.
This chapter describes how to configure the Ethernet Extender Switch using
its console by Commend Line.
Administration Console
Connect the DB9 straight cable to the RS-232 serial port of the device to
the RS-232 serial port of the terminal or computer running the terminal
emulation application.
Direct access to the administration console is achieved by directly
connecting a terminal or a PC equipped with a terminal-emulation program
(such as HyperTerminal) to the Ethernet Extender Switch console port.
When using the management method, configure the terminal-emulation
program to use the following parameters (you can change these settings
after login):
[Default parameters]
115,200bps
8 data bits
No parity
1 stop bit