B&B Electronics EIRM-EXTEND-8 - Manual - Manual (Page 127)

Manual Documentation Number: EIRM-EXTEND-8-1411m 121
B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 – www.bb-elec.com
B&B Electronics – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445 – www.bb-europe.com
3. Command Syntax:
bridge GROUP max-age MAXAGE
no bridge GROUP max-age
GROUP <1-1> The ID of the bridge group to which this maximum age
time is assigned.
MAXAGE <6-28> The maximum time, in seconds, to listen for the root
bridge.
4. Example:
The following example sets the max-age MAXAGE (28) of bridge
GROUP (1):
switch_a(config)#bridge 1 max-age 28
switch_a(config)#
Forward Delay (sec) (4..30):
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to set the time (in seconds) after which (if this bridge is
the root bridge) each port changes states to learning and forwarding.
Use the no parameter with this command to restore the default value.
3. Command Syntax:
bridge GROUP forward-time FORWARD_DELAY
no bridge GROUP forward-time
GROUP <1-1> The ID of the bridge group to which this delay time is
assigned.
FORWARD_DELAY <4-30> the forwarding time delay in seconds.
4. Example:
The following example sets the forward-time FORWARD_DELAY (30)
of bridge GROUP (1):
switch_a(config)#bridge 1 forward-time 30
switch_a(config)#
RSTP Port Setting
Priority(Granularity 16):
1. Command Mode: Interface mode