B&B Electronics EIRM-EXTEND-8 - Manual - Manual (Page 171)

Manual Documentation Number: EIRM-EXTEND-8-1411m 165
B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 – www.bb-elec.com
B&B Electronics – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445 – www.bb-europe.com
(no) ip igmp snooping enable
4. Example:
The following example enables IGMP snooping on the Ethernet Extender
Switch:
switch_a(config)# ip igmp snooping enable
switch_a(config)#
IGMP version:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
vlan1.1 means vlan 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface vlan1.1
switch_a(config-if)#
2. Usage:
Use ip igmp version command to set the current IGMP protocol version on
an interface.
To return to the default version, use the no ip igmp version command.
3. Command Syntax:
ip igmp version VERSION
no ip igmp version
VERSION IGMP protocol version number.
4. Example:
The following example sets the IGMP protocol version 3 on vlan1.1:
switch_a(config)#interface vlan1.1
switch_a(config-if)#ip igmp version 3
switch_a(config-if)#
Fast-leave:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
vlan1.1 means vlan 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface vlan1.1
switch_a(config-if)#