B&B Electronics EIRM-EXTEND-8 - Manual - Manual (Page 158)

152
Manual Documentation Number: EIRM-EXTEND-8-1411m
B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 – www.bb-elec.com
B&B Electronics – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445 – www.bb-europe.com
The following example specifies the IP address (192.168.1.100) of the
remote radius server host and assigns authentication and accounting
destination port number (1812):
switch_a(config)#radius-server host 192.168.1.100 auth-port 1812
switch_a(config)#
Secret Key:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to set the shared secret key between a Radius server and
a client.
3. Command Syntax:
(no) radius-server host IP-ADDRESS key KEY
IP-ADDRESS A.B.C.D specifies the IP address of the radius server host.
KEY specifies the secret key shared among the radius server and the 802.1x
client.
4. Example:
The following example specifies the IP address (192.168.1.100) of the
remote radius server host and set the secret key (ipi) shared among the
radius server and the 802.1x client:
switch_a(config)#radius-server host 192.168.1.100 key ipi
switch_a(config)#
Timeout:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to specify the number of seconds a Ethernet Extender
Switch waits for a reply to a radius request before retransmitting the
request.