B&B Electronics EIRM-EXTEND-8 - Manual - Manual (Page 167)

Manual Documentation Number: EIRM-EXTEND-8-1411m 161
B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 – www.bb-elec.com
B&B Electronics – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445 – www.bb-europe.com
Other Protocols
GVRP, IGMP Snooping, NTP
GVRP
GVRP:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use set gvrp enable bridge command to enable (set) and set gvrp disable
bridge command to disable (reset) GVRP globally for the bridge instance.
This command does not enable/disable GVRP in all ports of the bridge.
After enabling GVRP globally, use the set port gvrp enable command to
enable GVRP on individual ports of the bridge.
3. Command Syntax:
set gvrp enable bridge GROUP
set gvrp disable bridge GROUP
GROUP Bridge-group ID used for bridging.
4. Example:
The following example globally enables GVRP to bridge GROUP (1):
switch_a(config)#set gvrp enable bridge 1
switch_a(config)#
Dynamic VLAN creation:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use set gvrp dynamic-vlan-creation enable bridge command to enable
and set gvrp dynamic-vlan-creation disable bridge command to disable
dynamic VLAN creation for a specific bridge instance.
3. Command Syntax:
set gvrp dynamic-vlan-creation enable bridge GROUP
set gvrp dynamic-vlan-creation disable bridge GROUP
GROUP Bridge-group ID used for bridging.