B&B Electronics EIRM-EXTEND-8 - Manual - Manual (Page 113)

Manual Documentation Number: EIRM-EXTEND-8-1411m 107
B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 – www.bb-elec.com
B&B Electronics – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445 – www.bb-europe.com
Port Status
1. Command Mode: Exec mode or Privileged Exec mode
Logon to Exec Mode (View Mode) or Privileged Exec Mode (Enable
Mode).
The switch_a> or switch_a# prompt will show on the screen.
switch_a>
switch_a#
2. Usage:
Use the show interface command to display interface configuration and
status.
3. Command Syntax:
show interface IFNAME
IFNAME specifies the name of the interface for which status and
configuration information is desired.
4. Example:
The following example shows the use of show interface to display
interface configuration and status of the interface fe1 (port 1):
switch_a>show interface fe1
Rate Control
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2. Usage:
Use this command to specify the ingress/egress rate to be used for each
interface. The bandwidth value is in bits.
Use the no parameter with this command to remove the ingress/egress rate
to be used for each interface.
3. Command Syntax:
(no) rate-control ingress/egress VALUE
VALUE
<1-10000000000 bits> (usable units: k, m, g)
<1-999>k|m for 1 to 999 kilo bits or mega bits.