B&B Electronics EIRM-EXTEND-8 - Manual - Manual (Page 164)

158
Manual Documentation Number: EIRM-EXTEND-8-1411m
B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 – www.bb-elec.com
B&B Electronics – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445 – www.bb-europe.com
The following example specifies to set fixed rate bandwidth settings (59) in
the asymmetric mode for Ethernet Extender port 1 (vdsl1):
switch_a(config)#interface vdsl1
switch_a(config-if)#vdsl asym-fixedrate 59
switch_a(config-if)#
Symmetric Mode Max. Speed:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
vdsl1 means Ethernet Extender port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface vdsl1
switch_a(config-if)#
2. Usage:
Use this command to set Max. Speed settings in the symmetric mode for
Ethernet Extender port.
3. Command Syntax:
vdsl maxspeed SPEED
SPEED
1
Set max speed to 1Mbps
3 Set max speed to 3Mbps
5 Set max speed to 5Mbps
10 Set max speed to 10Mbps
15 Set max speed to 15Mbps
20 Set max speed to 20Mbps
25 Set max speed to 25Mbps
30 Set max speed to 30Mbps
40 Set max speed to 40Mbps
50 Set max speed to 50Mbps
4. Example:
The following example specifies to set Max. Speed settings (50) in the
symmetric mode for Ethernet Extender port 1 (vdsl1):
switch_a(config)#interface vdsl1
switch_a(config-if)#vdsl maxspeed 50
switch_a(config-if)#