B&B Electronics EIRM-EXTEND-8 - Manual - Manual (Page 109)

Manual Documentation Number: EIRM-EXTEND-8-1411m 103
B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 – www.bb-elec.com
B&B Electronics – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445 – www.bb-europe.com
Alarm Setting
Alarm-trigger if:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to enable or disable alarm trigger on interface.
3. Command Syntax:
(no) alarm-trigger if INTERFACE
INTERFACE specifies the interface.
4. Example:
The following example enables alarm trigger on interface “fe1” to Ethernet
Extender Switch:
switch_a(config)#alarm-trigger if fe1
switch_a(config)#
Alarm-trigger power:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to enable or disable alarm trigger of power source.
3. Command Syntax:
(no) alarm-trigger power POWER
POWER specifies the power source.
4. Example:
The following example enables alarm trigger of power “1” to Ethernet
Extender Switch:
switch_a(config)#alarm-trigger power 1
switch_a(config)#
Reboot
1. Command Mode: Privileged Exec mode