B&B Electronics EIRM-EXTEND-8 - Manual User Manual
Page 151

Manual Documentation Number: EIRM-EXTEND-8-1411m
145
B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 – www.bb-elec.com
B&B Electronics – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445 – www.bb-europe.com
Trap Community Name:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to specify trap community name for SNMP.
Use the no parameter with this command to remove trap community name
for SNMP.
3. Command Syntax:
snmp-server trap-community <1-5> NAME
no snmp-server trap-community <1-5>
<1-5> The trap community 1-5.
NAME The trap community name for SNMP.
4. Example:
The following example specifies trap community name 1 (name) for
SNMP:
switch_a(config)#snmp-server trap-community 1 name
switch_a(config)#
Trap Host IP Address:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to specify trap host IP address for SNMP.
Use the no parameter with this command to remove trap host IP address for
SNMP.
3. Command Syntax:
snmp-server trap-ipaddress <1-5> IP-ADDRESS
no snmp-server trap-ipaddress <1-5>
<1-5> The trap host IP address 1-5.
IP-ADDRESS The trap host IP address for SNMP. A.B.C.D specifies the
IP address.
4. Example: