B&B Electronics EIRM-EXTEND-8 - Manual - Manual (Page 162)

156
Manual Documentation Number: EIRM-EXTEND-8-1411m
B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 – www.bb-elec.com
B&B Electronics – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445 – www.bb-europe.com
VDSL
VDSL Configuration, VDSL Status, VDSL Counters
VDSL Configuration
VDSL Ports:
VDSL Retrain:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
vdsl1 means Ethernet Extender port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface vdsl1
switch_a(config-if)#
2. Usage:
Use this command to upgrade VDSL speed for Ethernet Extender port.
3. Command Syntax:
vdsl retrain
4. Example:
The following example specifies to upgrade VDSL speed for Ethernet
Extender port 1 (vdsl1):
switch_a(config)#interface vdsl1
switch_a(config-if)#vdsl retrain
switch_a(config-if)#
VDSL Settings:
Enable/Disable Asymmetric Mode:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
vdsl1 means Ethernet Extender port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface vdsl1
switch_a(config-if)#
2. Usage:
Use this command to enable the asymmetric mode for Ethernet Extender
port. Use the no parameter with this command to disable the asymmetric
mode for Ethernet Extender port.