B&B Electronics EIRM-EXTEND-8 - Manual - Manual (Page 153)

Manual Documentation Number: EIRM-EXTEND-8-1411m 147
B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 – www.bb-elec.com
B&B Electronics – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445 – www.bb-europe.com
4. Example:
The following example enables link up trap for SNMP:
switch_a(config)#snmp-server trap-type enable linkUp
switch_a(config)#
SNMP v1/v2c
Get Community Name:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use snmp-server community get command to specify and no snmp-
server community get command to remove get community name for
SNMP.
3. Command Syntax:
snmp-server community get NAME
no snmp-server community get
NAME The get community name for SNMP.
4. Example:
The following example specifies get community name (name) for SNMP:
switch_a(config)#snmp-server community get name
switch_a(config)#
Set Community Name:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use snmp-server community set command to specify and no snmp-
server community set command to remove set community name for
SNMP.
3. Command Syntax:
snmp-server community set NAME
no snmp-server community set