B&B Electronics EIRM-EXTEND-8 - Manual - Manual (Page 175)

Manual Documentation Number: EIRM-EXTEND-8-1411m 169
B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 – www.bb-elec.com
B&B Electronics – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445 – www.bb-europe.com
4. Example:
The following example enables report suppression for IGMPv2 reports on
vlan1.1:
switch_a(config)#interface vlan1.1
switch_a(config-if)#ip igmp version 2
switch_a(config-if)#ip igmp snooping report-suppression
switch_a(config-if)#
NTP
NTP Status:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use ntp enable command to enable NTP for the Ethernet Extender Switch.
Use no ntp enable command to disable NTP for the Ethernet Extender
Switch.
3. Command Syntax:
(no) ntp enable
4. Example:
The following example enables NTP for the Ethernet Extender Switch:
switch_a(config)#ntp enable
switch_a(config)#
NTP Server:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to specify the IP address or Domain name of NTP
server.
3. Command Syntax:
ntp server IP-ADDRESS｜DOMAIN-NAME
IP-ADDRESS A.B.C.D specifies the IP address of NTP server.