B&B Electronics EIRM-EXTEND-8 - Manual - Manual (Page 120)

114
Manual Documentation Number: EIRM-EXTEND-8-1411m
B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 – www.bb-elec.com
B&B Electronics – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445 – www.bb-europe.com
switch_a(config-if)#
Static MAC Entry
Static-MAC-Entry Forward:
5. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
6. Usage:
Use this command to statically configure a bridge entry to forward
matching frames.
7. Command Syntax:
bridge GROUP address MAC forward IFNAME VLANID
no bridge GROUP address MAC forward IFNAME VLANID
GROUP <1-1> Bridge-group ID used for bridging.
MAC the Media Access
Control (MAC) address in the
HHHH.HHHH.HHHH format.
IFNAME the interface on which the frame comes in.
VLANID The VID of the VLAN that will be enabled or disabled on the
bridge <2-4094>.
8. Example:
The following example configures a bridge GROUP (1) to forward
matching frames (MAC address 2222.2222.2222) to the interface fe1 (port
1) in vlan VLANID (2):
switch_a(config)#bridge 1 address 2222.2222.2222 forward fe1 vlan 2
switch_a(config)#
Static-MAC-Entry Discard:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to statically configure a bridge entry to discard matching
frames in a particular VLAN.