B&B Electronics EIRM-EXTEND-8 - Manual - Manual (Page 118)

112
Manual Documentation Number: EIRM-EXTEND-8-1411m
B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 – www.bb-elec.com
B&B Electronics – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445 – www.bb-europe.com
LEVEL <0-100> specifies the percentage of the threshold; percentage of
the maximum speed (pps) of the interface.
4. Example:
The following example shows setting storm-control level LEVEL (30) to
the interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#storm-control level 30
switch_a(config-if)#
Broadcast:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2. Usage:
Use storm-control broadcast enable command to enable broadcast traffic.
Use no storm-control broadcast command to disable broadcast traffic.
3. Command Syntax:
storm-control broadcast enable
no storm-control broadcast
4. Example:
The following example shows setting storm-control broadcast enable to
the interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#storm-control broadcast enable
switch_a(config-if)#
Multicast:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.