B&B Electronics EIRM-EXTEND-8 - Manual - Manual (Page 106)

100
Manual Documentation Number: EIRM-EXTEND-8-1411m
B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 – www.bb-elec.com
B&B Electronics – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445 – www.bb-europe.com
no service auto-config enable
4. Example:
The following example enables or disables auto save configuration to
Ethernet Extender Switch:
switch_a(config)#service auto-config enable
switch_a(config)#no service auto-config enable
switch_a(config)#
Auto Save Interval (5~65536 sec):
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to set the interval when the configuration would be
automatically saved. The range of interval value is from 5 to 65535. And
the default value is 30 seconds.
3. Command Syntax:
service auto-config interval WORD
WORD specifies the interval value.
4. Example:
The following example sets the interval WORD (10) when the
configuration would be automatically saved to Ethernet Extender Switch:
switch_a(config)#service auto-config interval 10
switch_a(config)#
Firmware Upgrade
1. Command Mode: Privileged Exec mode
Logon to Privileged Exec Mode (Enable Mode).
The switch_a# prompt will show on the screen.
switch_a#
2. Usage:
Use install image command to upgrade firmware from tftp server to
Ethernet Extender Switch.
3. Command Syntax: