3 advanced scanning, Feeding documents manually in the adf, Advanced scanning – Fujitsu Ricoh Fujitsu fi-7280 Color Duplex Document Scanner User Manual
Page 99: Appendix glossary introduction index contents top
Chapter 5 Various Ways to Scan
99
Feeding Documents Manually in the ADF
Documents can also be loaded manually one sheet at a time
in the ADF.
Normally, in automatic feeding, the scanner stops scanning
once all the documents loaded in the ADF paper chute
(feeder) have been scanned. In manual feeding, the scanner
waits for the next document to be loaded within a specified
time. Scanning will continue as long as another document is
loaded within the set time, and stops if no document is loaded.
By using this method, you can perform scanning as you check
the documents one by one.
Manual feeding is effective in the following cases.
z
To scan as you check the contents of each sheet.
z
To scan documents that cause multifeed or paper jam when loaded
together in the same batch.
z
To continue scanning documents such as magazine/newspaper
clippings that cannot be loaded together.
1
Enable manual feeding.
To do this, perform one of the following:
z
Enable manual feeding by selecting a value for [12: Manual Feed
Timeout] in the [Settings Menu] screen of the operator panel.
For details, refer to
z
Enable manual feeding in the Software Operation Panel.
For details, refer to
"Waiting Time in Manual Feed Mode [Manual-
2
Load a document in the ADF paper chute (feeder).
For details, refer to
"Chapter 2 How to Load Documents" (page 41)
3
Scan the document with the image scanning application.
For details, refer to the image scanning application manual.
After the document is scanned, the rollers inside the ADF keep
rotating, waiting for the next document to be loaded for the time
specified in the operator panel or Software Operation Panel.
4
Load the next document in the ADF paper chute (feeder).
The document is scanned.
5
until all documents are scanned.
Scanning will stop if no document is loaded within the set time.
5.3 Advanced Scanning
HINT
z
Pressing the [Stop/Clear] button on the operator panel will stop
the scan immediately.
z
When [Manual-feed timeout] is enabled, the scanner will wait for
the set time even if you start scanning with no document in the
ADF paper chute (feeder).
z
When you use manual feeding frequently, replacement cycle of
the consumables may be shortened.