Fujitsu Ricoh Fujitsu fi-7280 Color Duplex Document Scanner - Manual (Page 75)

Chapter 4 How to Use the Operator Panel
Appendix
Glossary
Introduction
Index
Contents
TOP
75
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
Configuring the
Scan Settings
■ Counting documents
1
Press the [Power] button on the operator panel.
The [Ready] screen is displayed on the LCD.
2
Press the [Menu] button.
The [Settings Menu] screen is displayed on the LCD.
3
Press the [ ] or [ ] button and select [9: Doc Counting
Mode], then press the [Scan/Enter] button to confirm.
The [Doc Counting Mode (More documents)] screen is displayed
on the LCD.
4
Load a document in the ADF paper chute (feeder), and
press the [Scan/Enter] button.
The number of sheets that are scanned is counted.
The number of counted sheets is displayed in Count.
Menu
Scan/Enter
Check
Power
Stop/Clear
2 [Menu] button
3 [ ]/[ ] button
[Scan/Enter] button
4 [Scan/Enter] button
1 [Power] button
ATTENTION
Documents may not be counted correctly if a multifeed occurs
during scanning.
HINT
z To reset Count, press the [Stop/Clear] button while the [Doc
Counting Mode (More documents)] screen is displayed.
z To end Doc Counting Mode, press the [Stop/Clear] button for
more than three seconds while the [Doc Counting Mode (More
documents)] screen is displayed.