Fujitsu Ricoh Fujitsu fi-7280 Color Duplex Document Scanner - Manual (Page 20)

Appendix
Chapter 1 Scanner Overview
Glossary
Introduction
Index
Contents
TOP
20
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
fi-7260/fi-7280
■ Front
Stopper
Lift up to adjust to the document length.
Operator panel
Consists of an LCD, buttons, and LED
indicator.
Can be used to operate the scanner or
check the status.
For details, refer to
"Chapter 4 How to Use
the Operator Panel" (page 61) .
ADF (Automatic Document Feeder)
Pulls and feeds the documents one sheet at a
time from the ADF paper chute (feeder).
Open to replace consumables or clean the
inside of the scanner.
Side guides
Guides the documents in width direction as
they are fed into the scanner.
Chute extension 2
Pull out to adjust to the document length.
ADF paper chute (feeder)
Holds the documents to be scanned.
ADF release tab
Pull this tab to open the ADF.
Flatbed
For scanning documents (e.g. thin paper,
books) that cannot be scanned with the ADF.
Chute extension 1
Pull out to adjust to the document length.
Stacker
Stacks up the ejected documents.
Transport lock switch
Locks the carrier unit (which is inside the
flatbed) to prevent damage during
transportation.