Fujitsu Ricoh Fujitsu fi-7280 Color Duplex Document Scanner - Manual (Page 202)

Chapter 9 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
202
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Operational
Settings
Waiting Time to Enter Power Saving Mode [Power
saving]
The waiting time for the scanner to enter power saving mode
can be specified.
1
Start up the Software Operation Panel.
For details, refer to "9.1 Starting Up the Software Operation Panel"
(page 163) .
2
From the listing on the left, select [Device Setting].
3
Use the slider to specify the waiting time before entering
power saving mode.
The value can range from 5 to 235 minutes (in increments of 5).
HINT
z Selecting the [Power off after a certain period of time] check box
turns the power off automatically if the scanner is left on for a
certain period of time without being used.
You can select the timeout period for the scanner to be
automatically turned off by [1 Hour]/[2 Hours]/[4 Hours]/[8
Hours].
z This setting can also be configured in the operator panel.