1 loading documents in the adf, Preparation, Loading documents in the adf – Fujitsu Ricoh Fujitsu fi-7280 Color Duplex Document Scanner User Manual
Page 42: Contents index, Appendix glossary introduction top
Chapter 2 How to Load Documents
42
This section explains how to load documents in the ADF.
Preparation
1
If you are loading multiple sheets, check the documents.
1 Check if the documents to be loaded are of the same width or
different widths.
Ways to load documents differ depending on whether they are the
same width or not.
If the document width varies, refer to
"Documents with Different Widths" (page
2 Check the number of sheets.
Up to 80 sheets can be loaded (with paper weight of 80 g/m
2
[20 lb]
and thickness of the document stack under 8 mm).
For details, refer to
2
Fan the documents.
1 Grab a stack of documents, which should be 8 mm or less.
2 Hold both ends of the documents and fan them a few times.
3 Rotate the documents by 90 degrees and fan them in the same
manner.
4 Perform steps
to
for all documents.
5 Align the edges of the documents.
2.1 Loading Documents in the ADF
HINT
For details about the paper size and quality required for normal
operations, refer to
"2.3 Documents for Scanning (ADF)" (page 45)
.
HINT
For more details about how to fan documents, refer to the Error
Recovery Guide.
The Error Recovery Guide is included in the Setup DVD-ROM. For
details about installation, refer to "Installing the Software" in
Getting Started.