Fujitsu Ricoh Fujitsu fi-7280 Color Duplex Document Scanner - Manual (Page 179)

Chapter 9 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
179
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Operational
Settings
■ Resetting the sheet counters
When you have replaced or cleaned a consumable part, reset the
corresponding counter by using the following procedure.
1
If you have replaced a consumable, click the [Clear]
button of the consumable that you replaced. If you
performed cleaning, click the [Clear] button of [After
cleaning].
The counter is reset to 0.
For ink counter, the value will be set to 100.
2
Click the [OK] button in the Software Operation Panel.
A confirmation message appears.
3
Click the [OK] button.
The settings are saved.
Remaining Ink Amount of ink remaining in the print
cartridge of the imprinter
(Only displayed when imprinter is
installed)
ATTENTION
If the scanner was turned off by unplugging the power cable, or
[Disable power switch] is selected, the number of scanned sheets
may not be counted in [Total Page Count].
For details about disabling the power switch, refer to
"Method of
Turning the Scanner ON/OFF [Power SW Control]" (page 203) .
Item Description