beautypg.com

Appendix glossary introduction index contents top – Fujitsu Ricoh Fujitsu fi-7280 Color Duplex Document Scanner User Manual

Page 174

background image

Chapter 9 Operational Settings

Appendix

Glossary

Introduction

Index

Contents

TOP

174

How to Load
Documents

Configuring the
Scan Settings

How to Use the
Operator Panel

Various Ways to
Scan

Daily Care

Troubleshooting

Replacing the
Consumables

Scanner
Overview

Operational
Settings

Document check area
specification for Multifeed
Detection

(page 197)

Selected range: Select this item to restrict the
area to run multifeed detection.

[Selected range] check box

Not selected

Enable / Disable (Middle): Specify whether to
enable or disable multifeed detection in the
selected area.

Enable / Disable
(When [Selected range] is selected)

Disable

Start (Middle): Specify the start position of the
area in length (mm) from the leading edge of
the document.

0 to 510 mm (in increments of 2)

0 mm

End (Middle): Specify the end position of the
area in length (mm) from the leading edge of
the document.

0 to 510 mm (in increments of 2)

0 mm

Intelligent Multifeed Function

(page 200)

When there is a paper of the same size
attached to a designated location on the page,
configure the scanner to memorize the location
of the attachment and not detect multifeeds for
that location.
Note that you first need to select [Check
Overlapping (Ultrasonic)] or [Check
Overlapping and length] in either the scanner
driver or the multifeed detection setting in

"Specifying a Multifeed Detection Method
[Multifeed]" (page 195)

.

This setting can also be configured in the
operator panel.

Manual mode / Auto mode 1 / Auto mode 2

Manual mode

Select to clear the overlap pattern (length,
location) memorized in Auto mode.
This setting can also be configured in the
operator panel.

[Clear overlap pattern] check box

Not selected

Select to record the multifeed pattern on the
dialog box to check an image that is detected as
multifeed.

[Auto-Memorize MF Pattern (only when MF
images are displayed)] check box

Not selected

Specify whether or not to memorize the
multifeed pattern upon power-off.

Remember / Do not remember

Do not remember

Item

Description

Parameter/Value

Factory Default