Fujitsu Ricoh Fujitsu fi-7280 Color Duplex Document Scanner - Manual (Page 203)

Chapter 9 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
203
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Operational
Settings
Method of Turning the Scanner ON/OFF [Power
SW Control]
The method by which the scanner is powered on/off can be
specified from one of the following:
z Press the [Power] button on the operator panel
z Unplug the power cable then plug it back in
z Have the scanner turn on/off in sync with the computer's power
1
Start up the Software Operation Panel.
For details, refer to "9.1 Starting Up the Software Operation Panel"
(page 163) .
2
From the listing on the left, select [Device Setting 2]
[Power SW Control].
3
Select one of the following:
9.8 Settings Related to Power ON/OFF
[Enable power switch] : Press the [Power] button on the operator
panel.
[Disable power switch] : Unplug the power cable then plug it back
in.
[Enable USB power
feeding] : Have the scanner turn ON/OFF in sync
with the computer's power.
ATTENTION
z When you select [Disable power switch], the scanner is not
turned off even if the [Power off after a certain period of time]
check box is selected in [Device Setting] on the Software
Operation Panel.
z Some types of computers and USB hubs keep supplying power
to the USB bus even after the computer is turned off.
In that case, the [Enable USB power feeding] mode may not
work properly.