Appendix glossary introduction index contents top – Fujitsu Ricoh Fujitsu fi-7280 Color Duplex Document Scanner User Manual
Page 196
Chapter 9 Operational Settings
196
3
Select a detection method.
Method
Description
None
Does not detect multifeed.
Check
Overlapping
(Ultrasonic)
Detects multifeed by the overlapping of
documents.
When this is selected, you can also specify the
two following options:
z
Specify the detection range by the length from
the top of the document.Proceed to
for more
details.
z
Ignore the multifeed when there is paper of the
same size attached to a designated location
on the page.Proceed to
"Ignoring Multifeed for a Set Pattern" (page
103)
for more details.
Check Length
Detects multifeed by the difference in length of the
documents.
Note that multifeeds cannot be detected
accurately when scanning a mixed batch of
different sizes.
Check
Overlapping
and Length
Detects multifeed by the combination of [Check
Overlapping (Ultrasonic)] and [Check Length].
Note that multifeeds cannot be detected
accurately when scanning a mixed batch of
different sizes.
When this is selected, you can also specify the
two following options:
z
Specify the detection range by the length from
the top of the document.Proceed to
for more
details.
z
Ignore the multifeed when there is paper of the
same size attached to a designated location
on the page.Proceed to
"Ignoring Multifeed for a Set Pattern" (page
103)
for more details.
Length
Select a length difference from 10/15/20 mm. Any
length under the specified value will not be
detected as multifeed.
ATTENTION
z
To scan documents with different lengths, specify [Check
Overlapping (Ultrasonic)].
z
When an attachment such as a sticky note, receipt, or photo is
attached on the document, the overlapping part of the
document may be falsely detected as multifeed if [Check
Overlapping (Ultrasonic)] is specified. In that case, specify
[Check Length].
Note however that [Check Overlapping (Ultrasonic)] can still be
used by restricting the detection range.
z
Multifeed cannot be detected when using the Carrier Sheet.
HINT
This setting can also be configured in the scanner driver.
Note that priority is given to the scanner driver setting.
Method
Description