Fujitsu Ricoh Fujitsu fi-7280 Color Duplex Document Scanner - Manual (Page 17)

Appendix
Chapter 1 Scanner Overview
Glossary
Introduction
Index
Contents
TOP
17
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
This section shows the names of the scanner parts.
fi-7160/fi-7180
■ Front
1.2 Parts and Functions
Stacker
Stacks up the ejected documents.
Operator panel
Consists of an LCD, buttons, and LED
indicator.
Can be used to operate the scanner or
check the status.
For details, refer to
"Chapter 4 How to Use
the Operator Panel" (page 61) .
ADF (Automatic Document
Feeder)
Pulls and feeds the documents one
sheet at a time from the ADF paper
chute (feeder).
Open to replace consumables or clean
the inside of the scanner.
Side guides
Guides the documents in width
direction as they are fed into the
scanner.
Chute extension 2
Pull out to adjust to the document length.
ADF paper chute (feeder)
Holds the documents to be scanned.
ADF release tab
Pull this tab to open the ADF.
Stacker extension 2
Slide out to adjust to the document
length.
Chute extension 1
Pull out to adjust to the document length.
Stacker extension 1
Slide out to adjust to the document
length.
Stopper
Lift up to adjust to the document
length.
Stacker stand
Used to adjust the tilt of the stacker.