Conditions for mixed batch scanning, Conditions for mixed batch, Contents index – Fujitsu Ricoh Fujitsu fi-7280 Color Duplex Document Scanner User Manual
Page 51: Appendix glossary introduction top
Chapter 2 How to Load Documents
51
Conditions for Mixed Batch Scanning
The following conditions apply when scanning a mixed batch
of documents with different paper weights/friction coefficients/
sizes.
Make sure to test a few sheets first to check if the documents
can be scanned.
For details, refer to
"Documents with Different Widths" (page
Paper direction
Align the direction of the paper fiber with the feed direction.
Paper weight
The following paper weights can be used:
27 to 413 g/m
2
(7.2 to 110 lb)
Friction coefficient
It is recommended to use the same type of paper from the same
manufacturer.
When papers of different manufacturers/brands are mixed, it affects the
feeding performance as the difference in the friction coefficient
increases.
The following friction coefficients are recommended:
0.35 to 0.60 (reference value for paper friction coefficient)
Document position
Use paper sizes that fit the 39 mm width of the pick roller in the center.
Paper size
When you scan a mixed batch with different sizes, not feeding the
documents straight may cause troubles such as paper jams or part of
the image to appear missing.
It is recommended to check the documents thoroughly before scanning
and also check the image if the document was skewed.
Documents that cannot be scanned in a mixed batch
The following types of documents cannot be mixed in the same batch:
z
Carbonless paper
z
Bond paper
z
Perforated documents
z
Thermal paper
z
Carbon-backed paper
z
OHP film
z
Tracing paper
39 mm
Pick roller
ATTENTION
z
When scanning a mixed batch with different sizes, documents are
more likely to skew because the side guides do not contact every
sheet.
z
Do not use [Check Length] or [Check Overlapping and Length] for
multifeed detection.