Fujitsu Ricoh Fujitsu fi-7280 Color Duplex Document Scanner - Manual (Page 194)

Chapter 9 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
194
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Operational
Settings
Scanning Thick Plastic Cards
[Feed Mode] (fi-7180/fi-7280)
When you use fi-7180/fi-7280 to scan at 300 dpi or less (80
ppm) in landscape, plastic cards with a thickness up to 1.4
mm can be scanned.
1
Start up the Software Operation Panel.
For details, refer to "9.1 Starting Up the Software Operation Panel"
(page 163) .
2
From the listing on the left, select [Device Setting 2]
[Feed Mode].
3
Specify the feed mode.
To scan a plastic card up to 1.4 mm thick, select [Thick cards (1.25
mm or more)].
Scanning at High Altitude [High Altitude Mode]
Select whether to enable or disable high altitude mode.
Enabling this setting allows you to use the scanner at 2,000 m
or higher altitudes.
1
Start up the Software Operation Panel.
For details, refer to "9.1 Starting Up the Software Operation Panel"
(page 163) .
2
From the listing on the left, select [Device Setting 2]
[High Altitude Mode].
3
Select whether to enable or disable [High Altitude Mode].
When you select [Enable], you can use the scanner at 2,000 m or
higher altitudes.
ATTENTION
Scanning speed slows down when you select [Thick cards (1.25
mm or more)].