Fujitsu Ricoh Fujitsu fi-7280 Color Duplex Document Scanner - Manual (Page 146)

Appendix
Chapter 8 Troubleshooting
Glossary
Introduction
Index
Contents
TOP
146
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Operational
Settings
Replacing the
Consumables
Scanner
Overview
Troubleshooting
An error (error code "U0:10", "U4:40" or "U5:4A")
is already displayed in the LCD after power-on.
Did you unlock the transport lock switch?
(fi-7260/fi-7280)
No
Turn off the scanner, and unlock the transport lock switch.
For details about how to turn off the scanner, refer to
"1.3 Turning the Power ON/
OFF" (page 25) .
For details, refer to "Installing the Scanner" in Getting Started.
Yes
Does the problem persist after turning the power off then
back on?
No
The scanner is operating correctly.
Yes
Is error code "U4:40" or "U5:4A" displayed in the LCD
while the LED indicator is flashing?
Yes
Close the ADF and the print section of the imprinter (only when imprinter is
installed) properly.
For details, refer to
"1.4 Opening/Closing the ADF" (page 27) .
If the indication does not return to the [Ready] screen after closing the ADF, check
the items in
"8.4 Before You Contact the Scanner Service Provider" (page 159)
first, then contact your FUJITSU scanner dealer or an authorized FUJITSU
scanner service provider.
No
If the problem persists, check the items in "8.4 Before You Contact the Scanner
Service Provider" (page 159) first, then contact your FUJITSU scanner dealer or
an authorized FUJITSU scanner service provider.