Fujitsu Ricoh Fujitsu fi-7280 Color Duplex Document Scanner - Manual (Page 140)

Appendix
Chapter 8 Troubleshooting
Glossary
Introduction
Index
Contents
TOP
140
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Operational
Settings
Replacing the
Consumables
Scanner
Overview
Troubleshooting
Scanning does not start.
Did you unlock the transport lock switch?
(fi-7260/fi-7280)
No
Turn off the scanner, and unlock the transport lock switch.
For details about how to turn off the scanner, refer to
"1.3 Turning the Power ON/
OFF" (page 25) .
For details, refer to "Installing the Scanner" in Getting Started.
Yes
Is the document loaded in the ADF paper chute (feeder)
correctly?
No
Reload the document in the ADF paper chute (feeder).
Yes
Is the ADF closed properly?
No
Close the ADF firmly.
If the document is caught in the ADF, remove the document and close the ADF.
Yes
Is the USB cable connected properly?
No
Connect the USB cable properly.
For details, refer to "Connecting the Cables" in Getting Started.
Yes
Is the connector on the USB cable broken or damaged?
Yes
Use a new cable and make sure that it is connected properly.
No
Does scanning start after turning the scanner off then back
on?
Yes
The scanner is operating correctly.
No
If the problem persists, check the items in "8.4 Before You Contact the Scanner
Service Provider" (page 159) first, then contact your FUJITSU scanner dealer or
an authorized FUJITSU scanner service provider.