Matrox MXO2 PCIe Host Adapter - Manual (Page 210)

186
Chapter 12, Using Matrox A/V Tools
• YUV Outputs YUV HDMI video. Select this only if you connected
the HDMI output to a device that accepts a YUV signal.
• RGB - calibrated Outputs adjusted RGB HDMI video using the
currently loaded Matrox HDMI calibration settings for your HDMI
monitor or television. For details on calibrating your HDMI monitor
and loading calibration settings using the Matrox HDMI Calibration
Utility, see
Chapter 7, “Calibrating Your HDMI Monitor for Video .”
• RGB - native Outputs native RGB HDMI video that does not apply
any calibration compensation. This is useful when you want to output
RGB HDMI video to a device other than an HDMI monitor or
television, such as an HDMI recorder to perform an export to tape.
$
3D Viewing Mode Select the 3D signal type that you want to be sent
from the HDMI output to your 3D monitor:
• Disabled Select this if you’re not outputting 3D video, or to disable
3D video output. You can still monitor 3D video, but you must select
the correct viewing mode on your 3D monitor manually.
• Side-by-side Outputs horizontally compressed side-by-side 3D
video (also referred to as side-by-side horizontal).
• Over/Under Outputs over/under 3D video (also referred to as top
bottom).
¦ Note This feature may not be supported on some 3D monitors.
5 Under Advanced , select Allow Super White to allow the highest
luminance level of your video output to exceed the standard maximum white
level. Select
Allow Super Black to allow the lowest luminance level of your
video output to fall below the standard black level. These options apply to
both the main analog output and secondary HDMI output.
¦ Note Super white and super black should not be allowed when producing
your final video production for broadcast.
6 Click OK to save your settings.