Matrox MXO2 PCIe Host Adapter - Manual (Page 147)

123
Creating a Matrox secondary color correction
$
Graphical Allows you to see a graphical representation of your changes
when you adjust the luma mapping settings. You can also modify the
luminance of your clip directly within the graph. For more information,
see
“Using the luma mapping graph” on page 119 .
$
Numerical Lets you adjust your luma mapping settings numerically by
entering values in the text boxes, or by dragging the corresponding sliders.
• Input Levels (Black and White) These controls let you fine-tune
your clip’s brightness and contrast by changing the luminance value
that represents black, white, or gray. Doing so expands or compresses
the range of luminance levels in your clip, which increases or decreases
your clip’s tonal range.
For example, by increasing the black value, you set black in your clip
to a higher luminance value, which compresses the luminance range
and darkens your clip proportionally.
• Output Levels (Black and White) These controls let you map the
values under Input Levels to any level of black and white. You can
reduce contrast in your clip, or reverse the luminosity of your clip by
setting black to a higher value than white.
• Gamma Use this to adjust the midtones in your clip without
adjusting black or white.
• Mask Allows you to apply a mask to your effect. For more information,
see “Applying a mask to your Matrox effects” on page 104 .
• Selective Key The selective key settings allow you to apply the color
correction effect to a specific range of pixels in your clip. Performing a
selective key is similar to performing a chroma or luma key, however, with a
selective key you are applying color correction to the keyed area instead of
transparency. For example, if you use the selective key properties to select
red as your
Hue color, the color correction will be applied to the red regions
in your clip. You can enable each keyer ( Hue , Saturation , and Luma )
individually, or enable all three at the same time to get the desired results.
$
Graphical Allows you to see a graphical representation of your changes
when you adjust the selective key Numerical settings. You can also
modify the settings directly within the graph and perform an auto key. For
more information, see
“Using the selective key graph” on page 126 .
$
Numerical Lets you adjust your key settings numerically by entering
values in the text boxes, or by dragging the corresponding sliders.
• Hue Key This type of key lets you select areas to be keyed (affected
by the color correction) based on their hue.
$
Enable Select this to enable the Hue Key properties and hue key
indicator in the selective key graph.