Enterasys Networks 1G58x-09 - Manual (Page 678)

Process Overview: Routing Protocol Configuration
Configuring VRRP
13-84 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Example
This example shows how to disable preempt mode on VLAN 1, VRID 1:
13.1.5.8 enable
Use this command to enable VRRP on an interface.
enable vlan vlan_id vrid
Syntax Description
Command Syntax of the “no” Form
The “no” form of this command disables VRRP on an interface:
no enable vlan vlan_id vrid
Command Type
Router command.
Command Mode
Router configuration: Matrix>Router(config-router)#
Command Defaults
None.
Matrix>Router(config)#router vrrp
Matrix>Router(config-router)#no preempt vlan 1 1
NOTE: Before enabling VRRP, you must set the other options described in this section.
Once enabled, you cannot make any configuration changes to VRRP without first
disabling it using the no enable vlan command.
vlan vlan_id Specifies the number of the VLAN on which to enable
VRRP. This VLAN must be configured for IP routing as
described in
Section 3.3.2 .
vrid Specifies the Virtual Router ID (VRID) associated with the
vlan_id. Valid values are from 1 to 255.