Enterasys Networks 1G58x-09 - Manual (Page 658)

Process Overview: Routing Protocol Configuration
Configuring DVMRP
13-64 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Command Mode
Interface configuration: Matrix>Router(config-if(Vlan ))#
Command Defaults
None.
Example
This example shows how to enable DVMRP on VLAN 1:
13.1.3.2 ip dvmrp metric
Use this command to configure the metric associated with a set of destinations for DVMRP reports.
ip dvmrp metric metric
Syntax Description
Command Type
Router command.
Command Mode
Interface configuration: Matrix>Router(config-if(Vlan ))#
Command Defaults
None.
Matrix>Router(config)#interface vlan 1
Matrix>Router(config-if(Vlan 1))#ip dvmrp
metric Specifies a metric associated with a set of destinations for
DVMRP reports. Valid values are from 0 to 31. Entering
a 0 value will reset the metric back to the default value of
1.
NOTE: To reset the DVMRP metric back to the default value of 1, enter ip dvmrp
metric 0.