3 set sntp broadcastdelay, 4 set sntp poll-interval, Set sntp broadcastdelay -62 – Enterasys Networks 1G58x-09 User Manual
Page 532: Set sntp poll-interval -62, Section 11.2.4.3, Poll-interval, Section 11.2.4.4
Logging and Network Management Command Set
Configuring Simple Network Time Protocol (SNTP)
11-62
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Command Mode
Read-Write.
Example
This example shows how to enable SNTP in broadcast mode:
11.2.4.3 set sntp broadcastdelay
Use this command to set the SNTP time to wait for a response from an SNTP server, in
milliseconds, when in broadcast mode.
set sntp broadcastdelay time
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the SNTP broadcast delay to 12000 milliseconds
:
11.2.4.4 set sntp poll-interval
Use this command to set the SNTP poll interval in seconds. This is the time between SNTP requests
when operation in broadcast or unicast mode.
set sntp poll-interval interval
Matrix>set sntp broadcast
time Specifies
broadcast delay time in milliseconds. Valid
values are 1 to 999999. Default value is 3000.
Matrix>set sntp broadcastdelay 12000