Enterasys Networks 1G58x-09 - Manual (Page 340)

Spanning Tree Configuration Command Set
Reviewing and Setting Spanning Tree Port Parameters
6-54 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
6.2.2.24 clear spantree spanguardtrapenable
Use this command to reset the Spanning Tree span guard trap function back to the default state of
disabled.
clear spantree spanguardtrapenable
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to reset the span guard trap function to disabled:
6.2.2.25 show spantree adminpoint
Use this command to display the administrative point-to-point status of the LAN segment attached
to a port.
show spantree adminpoint port-string
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Matrix>clear spantree spanguardtrapenable
port-string Specifies the port(s) for which to display point-to-point
status. For a detailed description of possible port-string
values, refer to
Section 4.1.2 .