Section 6.2.2, Commands – Enterasys Networks 1G58x-09 User Manual
Page 322
Spanning Tree Configuration Command Set
Reviewing and Setting Spanning Tree Port Parameters
6-36
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
6.2.2
Reviewing and Setting Spanning Tree Port Parameters
Purpose
To display and set Spanning Tree port parameters, including enabling or disabling the Spanning
Tree algorithm on one or more ports, displaying blocked ports, displaying and setting Spanning
Tree port priorities and costs, configuring edge port parameters, configuring the span guard
function, and setting point-to-point protocol mode.
Commands
The commands needed to review and set Spanning Tree port parameters are listed below and
described in the associated section as shown.
•
show spantree portadmin (
•
set spantree portadmin (
)
•
clear spantree portadmin (
)
•
show spantree blocked ports (
•
show spantree portpri (
•
set spantree portpri (
)
•
clear spantree portpri (
)
•
show spantree portcost (
)
•
set spantree portcost (
•
)
•
show spantree adminedge (
)
•
set spantree adminedge (
)
•
•
show spantree spanguard (
)
•
set spantree spanguard (
)
•
clear spantree spanguard (
•
show spantree spanguardtimeout (
•
set spantree spanguardtimeout (