Enterasys Networks 1G58x-09 - Manual (Page 605)

Process Overview: Routing Protocol Configuration
Configuring RIP
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 13-11
Example
This example shows how to set the RIP receive version to 2 for update packets received on VLAN 1:
About RIP Authentication
The following tasks must be completed to configure RIP authentication on the Matrix E1 device:
1. Create a key chain as described in Section 13.1.1.9 .
2. Add a key to the chain as described in Section 13.1.1.10 .
3. Specify an authentication string for the key as described in Section 13.1.1.11 .
4. Set the time periods the authentication string can be received and sent as valid as described in
Section 13.1.1.12 and Section 13.1.1.13 .
5. Enable a key chain for use on an interface as described in Section 13.1.1.14 .
6. Specify an authentication mode as described in Section 13.1.1.15 .
13.1.1.9 key chain
Creates or deletes a key chain used globally for RIP authentication.
key chain name
Syntax Description
Command Syntax of the “no” Form
The “no” form of this command deletes the specified key chain:
no key chain name
Command Type
Router command.
Command Mode
Global configuration: Matrix>Router(config)#
Matrix>Router(config)#interface vlan 1
Matrix>Router(config-if(Vlan 1))#ip rip receive version 2
name Specifies a name for the key chain.