Enterasys Networks 1G58x-09 - Manual (Page 743)

Security Configuration Command Set
Configuring MAC Locking
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 14-61
14.3.4.17set maclock trap
Use this command to enable or disable MAC lock trap messaging. When enabled, this authorizes
the device to send an SNMP trap message if an end station is connected that exceeds the maximum
values configured using the set maclock firstarrival and set maclock static commands. Violating
MAC addresses are dropped from the device’s routing table.
set maclock trap port-string {enable | disable}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable MAC lock trap messaging on Fast Ethernet front panel port 3:
port-string Specifies the port on which MAC lock trap messaging
will be enabled or disabled. For a detailed description of
possible port-string values, refer to
Section 4.1.2 .
enable | disable Enables or disables MAC lock trap messaging.
Matrix>set maclock trap fe.0.3 enable