Enterasys Networks 1G58x-09 - Manual (Page 467)

IGMP Configuration Command Set
Configuring IGMP VLAN Registration
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 10-11
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set VLAN 1 as an IGMP registered VLAN:
10.2.4.3 set igmp mode ipaddress
Use this command to set the virtual IP address through which multicast traffic will be forwarded to
all subscribing, or “open” ports.
set igmp mode ipaddress ip_address
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
vlan_id Specifies the IGMP registered VLAN.
Matrix>set igmp mode vlan 1
ip_address Specifies the virtual IP address associated with the
vlan_id used in the set igmp mode vlan command
(
Section 10.2.4.2 ).