Enterasys Networks 1G58x-09 - Manual (Page 623)

Process Overview: Routing Protocol Configuration
Configuring OSPF
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 13-29
Command Defaults
None.
Example
This example shows how to enable routing for OSPF process 1:
13.1.2.2 network
Use this command to configure area IDs for OSPF interfaces.
network ip_address wildcard_mask area area-id
Syntax Description
Command Syntax of the “no” Form
The “no” form of this command removes OSPF routing for interfaces identified by
the IP address and mask parameters:
no network ip_address wildcard_mask area area-id
Command Type
Router command.
Command Mode
Router configuration: Matrix>Router(config-router)#
Command Defaults
None.
Matrix>Router#conf terminal
Matrix>Router(config)#router ospf 1
Matrix>Router(config-router)#
ip_address Specifies the IP address of an interface or a group of
interfaces within the network address range.
wildcard_mask Specifies the IP-address-type mask that includes “don't
care” bits.
area area-id Specifies the area-id to be associated with the OSPF address
range. Valid values are decimal values or IP addresses. A
subnet address can be specified as the area-id to associate
areas with IP subnets.