3 enabling router configuration modes, Enabling router configuration modes -96, Router cli configuration modes – Enterasys Networks 1G58x-09 User Manual
Page 144: Table 3-10, Section 3.3.3
Preparing the Device for Router Mode
Enabling Router Configuration Modes
3-96
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
3.3.3
Enabling Router Configuration Modes
The Matrix E1 CLI provides different modes of router operation for issuing a subset of commands
from each mode.
describes these modes of operation.
NOTE: The command prompts used in examples throughout this guide show a system
where VLAN 1 has been configured for routing. The prompt changes depending on your
current configuration mode, and the interface types and numbers configured for routing
on your system.
Table 3-10
Router CLI Configuration Modes
Use this mode...
To...
Access method...
Prompt...
Privileged EXEC
Mode
•
Set system
operating
parameters
•
Show
configuration
parameters
•
Save/copy
configurations
Type router
from switch mode.
Matrix>Router#
Global
Configuration
Mode
Set system-wide
parameters.
Type
configure
terminal
from
Privileged EXEC
mode.
Matrix>Router(config)#
Interface
Configuration
Mode
Configure router
interfaces.
Type interface
and the interface’s
vlan_id from
Global
Configuration
mode.
Matrix>Router
(config-if(Vlan
Router
Configuration
Mode
Set IP protocol
parameters.
Type router
and the protocol
name from Global
or Interface
Configuration
mode.
Matrix>Router
(config-router)#