2 setting igmp query interval and response time, 1 show igmp query-interval, Show igmp query-interval -4 – Enterasys Networks 1G58x-09 User Manual
Page 460: Section 10.2.2, Commands
IGMP Configuration Command Set
Setting IGMP Query Interval and Response Time
10-4
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
10.2.2 Setting IGMP Query Interval and Response Time
Purpose
To display and set IGMP query interval and response time settings. These commands work together
to remove ports from an IGMP group. Query interval specifies how often IGMP host queries are
sent. Response time specifies the maximum query response time.
Commands
The commands needed to display and set IGMP query interval and response time are listed below
and described in the associated sections as shown.
•
show igmp query-interval (
)
•
set igmp query-interval (
)
•
show igmp response-time (
•
set igmp response-time (
)
10.2.2.1 show igmp query-interval
Use this command to display the IGMP query interval setting.
show igmp query-interval
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display IGMP query count status:
Matrix>show igmp query-interval
IGMP query interval is 125 seconds.