Enterasys Networks 1G58x-09 - Manual (Page 621)

Process Overview: Routing Protocol Configuration
Configuring OSPF
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 13-27
• Configure OSPF authentication. ip ospf authentication-key ( Section 13.1.2.11 )
ip ospf message digest key md5 ( Section 13.1.2.12 )
Configure OSPF Areas.
• Configure an administrative
distance. distance ospf ( Section 13.1.2.13 )
• Define the range of addresses to be
used by Area Boundary Routers
(ABRs). area range ( Section 13.1.2.14 )
• Enable area authentication. area authentication ( Section 13.1.2.15 )
• Define an area as a stub area. area stub ( Section 13.1.2.16 )
• Set the cost value for the default
route that is sent into a stub area. area default cost ( Section 13.1.2.17 )
• Define an area as an NSSA. area nssa ( Section 13.1.2.18 )
Create virtual links. area virtual-link ( Section 13.1.2.19 )
Enable passive OSPF mode on an
interface. passive-ospf ( Section 13.1.2.20 )
Enable redistribution from non-OSPF
routes. redistribute ( Section 13.1.2.21 )
Limit link state database overflow. database-overflow ( Section 13.1.2.22 )
Table 13-2 OSPF Configuration Task List and Commands (Continued)
To do this... Use these commands...