Enterasys Networks 1G58x-09 - Manual (Page 325)

Spanning Tree Configuration Command Set
Reviewing and Setting Spanning Tree Port Parameters
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 6-39
6.2.2.3 clear spantree portadmin
Use this command to reset the default Spanning Tree admin status to enable on one or more ports.
clear spantree portadmin [port-string]
Syntax Description
Command Defaults
If port-string is not specified, status will be reset on all ports.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to re-enable Spanning Tree on Fast Ethernet front panel port 12:
6.2.2.4 show spantree blocked ports
Use this command to display the blocked ports in one or more Spanning Trees. A port in this state
does not participate in the transmission of frames, thus preventing duplication arising through
multiple paths existing in the active topology of the bridged LAN. It receives Spanning Tree
configuration messages, but does not forward packets.
show spantree blockedports [sid]
Syntax Description
Command Defaults
If sid is not specified, SID 0 will be displayed.
port-string (Optional) Resets status to enable on specific port(s). For
a detailed description of possible port-string values, refer
to
Section 4.1.2 .
Matrix>clear spantree portadmin fe.0.12
sid (Optional) Displays status for specific SID(s).