Enterasys Networks 1G58x-09 - Manual (Page 638)

Process Overview: Routing Protocol Configuration
Configuring OSPF
13-44 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Syntax Description
Command Syntax of the “no” Form
The “no” form of this command removes the cost value from the summary route
that is sent into the stub area:
no area area-id default-cost
Command Type
Router command.
Command Mode
Router configuration: Matrix>Router(config-router)#
Command Defaults
None.
Example
This example shows how to set the cost value for stub area 10 to 99:
13.1.2.18area nssa
Use this command to configure an area as a not so stubby area (NSSA). An NSSA allows some
external routes represented by external Link State Advertisements (LSAs) to be imported into it.
This is in contrast to a stub area that does not allow any external routes. External routes that are not
imported into an NSSA can be represented by means of a default route. This configuration is used
when an OSPF internetwork is connected to multiple non-OSPF routing domains.
area area-id nssa [default-information-originate]
area-id Specifies the stub area. Valid values are decimal values or IP
addresses.
cost Specifies a cost value for the summary route that is sent into
a stub area by default. Valid values are 24-bit numbers, from
0 to 16777215.
Matrix>Router(config)#router ospf 1
Matrix>Router(config-router)#area 10 default-cost 99