Enterasys Networks 1G58x-09 - Manual (Page 131)

General Configuration Command Set
Configuring Enterasys and Cisco Discovery Protocols
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 3-83
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to configure port ge.0.5 to transmit voice traffic to VLAN 2:
port-string Specifies the port(s) on which tagging will be set. For a
detailed description of possible port-string values, refer to
Section 4.1.2 .
vlan-id Instructs an attached Cisco IP phone to transmit to a specific
VLAN. Valid values are 1 - 4094. For information on
creating and configuring VLANs, refer to
Chapter 7 .
none Specifies that no VVID will be included in CiscoDP PDUs
transmitted out this port.
dot1p Instructs an attached Cisco IP phone to transmit 802.1p
priority tagged traffic.
untagged Instructs an attached Cisco IP phone to transmit untagged
traffic.
Matrix>set port ciscodp vvid ge.0.5 2