7 configuring access lists, 1 show access-lists, Configuring access lists -89 14.3.7.1 – Enterasys Networks 1G58x-09 User Manual
Page 771: Show access-lists -89, Ss lists, refer to, Section 14.3.7, Ss lists (acls), 7 configuring access lists purpose, Commands
Security Configuration Command Set
Configuring Access Lists
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
14-89
Command Mode
Read-Write.
Command Defaults
None.
Example
This example shows how to clear the SSH configuration:
14.3.7 Configuring Access Lists
Purpose
To review and configure security access lists (ACLs), which permit or deny access to routing
interfaces based on protocol and source IP address restrictions.
Commands
The commands needed to review and configure security access lists are listed below and described
in the associated section as shown:
•
show access-lists (
)
•
access-list (standard) (
•
access-list (extended) (
)
•
ip access-group (
14.3.7.1 show access-lists
Use this command to display configured IP access lists when operating in router mode.
show access-lists [access-list-number]
Matrix>clear ssh config
ROUTER: This command can be executed when the device is in router mode only.
For details on how to enable router configuration modes, refer to