Enterasys Networks 1G58x-09 - Manual (Page 85)

General Configuration Command Set
Setting Basic Device Properties
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 3-37
3.2.2.9 show version
Use this command to display hardware and firmware information. Refer to Section 3.2.3 for
instructions on how to download a firmware image. If a firmware image has been downloaded to
the switch since the last reboot, a message will be displayed indicating that fact. If no download has
taken place, no message will be displayed.
show version
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display version information. This example illustrates the message that
is displayed if a firmware image has been downloaded to the switch since the last reboot.
Table 3-5 provides an explanation of the command output.
Matrix>show version
Boot Prom Version: 01.01.00
Slot Ports Model Serial Number HW Version FW Version
---- ----- --------- ------------- ---------- -----------
0 48 1H582-51 03032222210N 0 03.04.04
1 8 1H-8FX N/A N/A N/A
2 2 1G-2TX N/A N/A N/A
3 2 1G-2GBIC N/A N/A N/A
Note: Image file firmware/images/03_05_06.fls has been downloaded
and will take effect on next reset.